Pouring Shield For Kitchenaid 4.5 5Qt Tilt Head Stand Mixers Bowls, Replace Kn1Ps Pouring Shield Mixers Parts & Accessories ( O

Kn1Ps 45 Bowl Pouring Shield Tilt Head Parts W10616906 For Kitchenaid Stand Mixer Name: Bowl Pouring Shield Tilt Head Material: Plastic Color: Clear Attachments: Mixer,Blender Type: Stand Model: Kn1Psplease Note:Ol> This Section Doesnt Fit Kitchenaid Professional 5 Plus Mixer Please Check The Model Number Before Purchasing To Make Sure It Is What You Need We Provide Clear Pictures, Measurements Where Possible Please Refer To Figure 2-3 For Size Details, Please Allow 05-1 Inch Difference Due To Manual Measurement(1Inch=254Cm)Ol>Installation Pouring Shield: Turn The Speed Control To The Off Position And Unplug The Mixer From The Outlet Attach The Bowl Along With The Flat Beater, Dough Hook, Or Wire Whip Lower And Lock The Motor Head From The Front Of The Mixer, Slide The Pouring Shield Over The Bowl Until The Shield Is Centered The Bottom Rim Of The Shield Should Fit Within The Bowlusing The Pouring Shield :For The Best Results, Rotate The Shield So The Motor Head Covers The U Shaped Gap In The Shield The Pouring Chute Will Be Just To The Right Of The Attachment Hub As You Face The Mixerpour The Ingredients Into The Bowl Through The Pouring Chuteremoving Pouring Shield : Turn The Speed Control To The Off Position And Unplug The Mixer From The Outlet Slide The Pouring Shield Off The Bowl From The Front Of The Mixerto Clean Pouring Shield:Ol> Wash The Pouring Shield In Warm, Soapy Water Or Place It In The Top Rack Of Your Dishwasher Note: Do Not Scrape Bowl While The Mixer Is Running Turn Mixer Off Slide The Pouring Shiel